标准号:ISO 15011-2-2003
实施状态:作废
中文名称:焊接和相关工艺中的保健和安全.对电弧焊产生的烟尘和气体取样的实验室方法.第2部分:除臭氧外气体的排放率的测定
英文名称:Health and safety in welding and allied processes - Laboratory method for sampling fume and gases generated by arc welding - Part 2: Determination of emission rates of gases, except ozone
发布日期:2003-05
被替代标准:ISO 15011-2-2009
代替标准:ISO/FDIS 15011-2-2002
采用标准:DIN EN ISO 15011-2-2003,IDT;BS EN ISO 15011-2-2003,IDT;EN ISO 15011-2-2003,IDT;NF A88-200-2-2003,IDT;SN EN ISO 15011-2-2003,IDT;OENORM EN ISO 15011-2-2003,IDT;UNE-EN ISO 15011-2-2004,IDT
起草单位:ISO/TC 44
标准简介:This European Standard provides guidance on the determination of emission rates of gases generated by arc welding using a fume box technique. It describes the test principle, gives a possible fume box arrangement and considers methods for sampling and analysis.
The following gases that can be produced during arc welding are covered:
- Carbon monoxide (CO);
- Carbon dioxide (CO2);
- Nitrogen oxide (NO);
- Nitrogen dioxide (NO2).
The fume box described in this standard can also be used for the determination of organic gases produced in the arc welding of coated metals, e.g. primed, painted or plastic coated material (see annex A for further information).
Ozone is considered in EN ISO 15011-3.
文件格式:PDF
文件大小:515.37KB
文件页数:18
(以上信息更新时间为:2019-11-23)
ISO 15011-2-2003 焊接和相关工艺中的保健和安全.对电弧焊产生的烟尘和气体取样的实验室方法.第2部分_除臭氧外气体的排放率的测定.pdf
(515.37 KB)
|
|