标准号：ISO 11119-1-2002
实施状态：作废
中文名称：混合结构气瓶.规范和试验方法.第1部分:铁环包裹的复合气瓶
英文名称：Gas cylinders of composite construction - Specification and test methods - Part 1: Hoop wrapped composite gas cylinders
发布日期：2002-05
被替代标准：ISO 11119-1-2012
代替标准：ISO/FDIS 11119-1-2001
起草单位：ISO/TC 58
标准简介：This part of ISO 11119 specifies requirements for composite gas cylinders up to and including 450 litres water capacity, for the storage and conveyance of compressed or liquefied gases with test pressures up to and including 650 bar<up1)>. The cylinders are constructed in the form of a seamless metallic liner over-wrapped with carbon fibre or aramid fibre or glass fibre (or a mixture thereof) in a resin matrix, or steel wire, to provide circumferential reinforcement.
This part of ISO 11119 addresses cylinders with a design life from 10 a to non-limited life. For cylinders with a design life in excess of 15 a, and in order for these cylinders to remain in service beyond 15 a, requalification of these cylinders is recommended.
This part of ISO 11119 does not address the design, fitting and performance of removable protective sleeves. Where these are fitted, they should be considered separately.
NOTE 1 ISO 11439 applies to cylinders intended for use as fuel containers on natural gas vehicles.
NOTE 2 ISO 11623 covers periodic inspection and retesting of composite cylinders.
note: 1) 1bar = 10<up5>Pa.
文件格式：PDF
文件大小：910.99KB
文件页数：36
（以上信息更新时间为：2019-11-23）
ISO 11119-1-2002 混合结构气瓶.规范和试验方法.第1部分_铁环包裹的复合气瓶.pdf
(910.99 KB)
|
|
